Firmware
The VBus®/LAN interface adapter is designed for the direct connection of the controller to a PC or router. It enables easy access to the controller via the local network of the owner. Thus, controller access, system parametrisation and data read-out can be effected from every workstation of the network. The VBus®/LAN interface adapter is suitable for all controllers equipped with a RESOL VBus®. A version of the RESOL ServiceCenter software is included. VBus.net access is not possible with this product. For VBus.net access, you will need a KM2 Communication module or a DL2 Plus.
- Start the application attached (The application window opens)
- Click the Aktualisieren button
- Select the adapter from the list that appears
The IP and MAC addresses are automatically displayed in the corresponding input boxes. The Update button becomes active.
- Disconnect the interface adapter from the mains (plug out the mains adapter!)
- Open the adapter housing (see chap. 1 in the manual)
- Press the reset button and keep it pressed (button position: see chap. 2 in the manual), reestablish the mains connection (plug in the mains adapter)
The front LED becomes permanently red.
- Cease pressing the reset button
- Wait a few seconds, until the front LED starts flashing quickly
- Click the Update button
If the update has been successfully completed, the message Aktualisierung erfolgreich appears in the application window.
- Click OK to acknowledge the message
- Restart the interface adapter (disconnect from mains, wait a few seconds, then reconnect)
If an error message appears or the front LED does not start fl ashing, restart the interface adapter and try again.