Sensors
Immersion sleeves
Because of the short component length, it is recommended to use the immersion sleeve TH30 with the temperature sensor FKP5,5 or FRP5,5.Advice:
Standard-screw connection thread of the immersion sleeves ½"
Attention:
In case of domestic water installations only use stainless steel immersion sleeves.
:
28000560 |
Price on request
FAP13 Outdoor temperature sensor
The RESOL FAP13 is used for measuring the outdoor temperature with a Pt1000 measuring element. The FAP13 is placed in a weather-resistant housing and is designed for mounting outdoors. Cable glands for the sensor cables at the bottom of the housing allow easy installation.
CS10 Solar cell
The solar cell is used for measuring the irradiation intensity. The short-circuit current rises with increasing irradiation intensity. Depending on the controller, the sensor can also be used for additional plausibility control or direct control. The connecting cable can be extended to 100 m.
Grundfos Direct Sensors™ (Solar/DHW)
VFS Grundfos Direct Sensors™ measure the temperature and the flow rate with a single measuring element. Based on the vortex principle, the sensor measures the flow rate by means of the pressure differences caused by the fluid turbulences occurring at the insert. Grundfos Direct Sensors™ can be used in aggressive media as well as in domestic water and thus are ideal for measuring the flow rate and the heat quantity in solar thermal and heating systems.The digital VFD Grundfos Direct Sensors™ measure the temperature and the flow rate with a single measuring element and then transmit the measured values directly via the RESOL VBus® protocol. Grundfos Direct Sensors™ can be used in aggressive media as well as in domestic water and thus are ideal for measuring the flow rate and the heat quantity in solar thermal and heating systems. VFD 1 - 12 l are designed for systems with low flow rates. VFD 2 - 40 l are designed for systems with higher flow rates. The VFD 2 - 40 l fast is ideal for DHW exchange modules due to its high-speed reaction time.
RPS Grundfos Direct Sensors™ measure the temperature and the relative pressure with a single measuring element. They can be optimally used for leakage and overpressure monitoring. Grundfos Direct Sensors™ can be used in aggressive media as well as in domestic water and thus are ideal for the application in solar thermal and heating systems.
The digital RPD Grundfos Direct Sensors™ measure the temperature and the relative pressure with a single measuring element and then transmit the measured values directly via the RESOL VBus® protocol. They can be optimally used for leakage and overpressure monitoring. Grundfos Direct Sensors™ can be used in aggressive media as well as in domestic water and thus are ideal for the application in solar thermal and heating systems.
RCP12 Room control unit
With the RCP12, the heating curve can be comfortably adjusted from the living area. The integrated sensor measures the room temperature. The additional operating mode switch enables a quick change of modes, e. g. from Automatic to Night mode. The additional operating mode switch enables a quick change of modes, e. g. from Automatic to Night mode.
Radon FRn
The radon sensor measures the radon concentration in residential buildings and calculates an average value over up to one year in its internal memory. This level of radon concentration is displayed by means of LED flashing codes. Additionally, the radon sensor measures the relative humidity and the room temperature.
