Logiciel résident
L’adaptateur VBus®/LAN sert à brancher le régulateur sur un PC ou un routeur et permet ainsi l’accès au régulateur à travers le réseau local de l’utilisateur. Cela permet d’accéder au régulateur, de configurer l'installation et d’effectuer le bilan des données enregistrées à partir de toute station raccordée au réseau.
L’adaptateur interface VBus®/LAN peut être branché sur tous les régulateurs dotés d’un VBus®. Il ne permet pas d'accéder à VBus.net. Pour accéder au portail de visualisation VBus.net, il vous faut un module de communication KM2 ou un Datalogger DL2 Plus.
- Start the application attached (The application window opens)
- Click the Aktualisieren button
- Select the adapter from the list that appears
The IP and MAC addresses are automatically displayed in the corresponding input boxes. The Update button becomes active.
- Disconnect the interface adapter from the mains (plug out the mains adapter!)
- Open the adapter housing (see chap. 1 in the manual)
- Press the reset button and keep it pressed (button position: see chap. 2 in the manual), reestablish the mains connection (plug in the mains adapter)
The front LED becomes permanently red.
- Cease pressing the reset button
- Wait a few seconds, until the front LED starts fl ashing quickly
- Click the Update button
If the update has been successfully completed, the message Aktualisierung erfolgreich appears in the application window.
- Click OK to acknowledge the message
- Restart the interface adapter (disconnect from mains, wait a few seconds, then reconnect)
If an error message appears or the front LED does not start fl ashing, restart the interface adapter and try again.